Quick Answer: Usually yes in a midsize-or-larger SUV or minivan, and it’s tight-but-often-doable in a sedan trunk. The current UPPAbaby Cruz folds to roughly 33″ H x 23″ W x 16.5″ L with the seat attached (about 25–28 lbs), so two of them side by side need close to 33″ of trunk width, or you can angle one diagonally in a narrower space. Measure your trunk’s narrowest point before assuming it will work.
Key Takeaways
- The UPPAbaby Cruz folds to about 33″ H x 23″ W x 16.5″ L (with seat attached) — measure your own trunk against those numbers rather than a generic minimum.
- The Cruz cannot take a RumbleSeat like the Vista can; its only official second-child option is the standing PiggyBack board, not a second seat.
- Sedan trunks (roughly 13–20 cu ft) are the tightest fit; compact-to-midsize SUVs (roughly 20–40+ cu ft) and minivans give the most breathing room.
- Fold both strollers fully, remove detachable seats/canopies where possible, and load one upright and one on its side or at an angle rather than stacking flat.
How to Measure Your Trunk Space for Two Strollers
Before you assume two UPPAbaby Cruz strollers will (or won’t) fit, measure your actual trunk rather than relying on a generic rule of thumb. Use a tape measure to record three numbers at the trunk’s narrowest points, since a sloped rear window or a raised load floor can shrink the usable space well below the vehicle’s published cargo figure:
- Width — the tightest point between the wheel wells, not just the opening.
- Depth (floor to seatback) — how far back a folded stroller can sit before it hits the back seats.
- Height — especially in vehicles with a sloped hatch or a low parcel shelf.
Compare those measurements to the folded dimensions of your specific stroller (see the next section), and add a little buffer, since car trunks are rarely perfectly rectangular. If you’re shopping for a second stroller specifically to pair with a Cruz you already own, bring the tape measure — or the numbers below — with you.
UPPAbaby Cruz Folded Dimensions (Official Specs)
According to UPPAbaby’s own product page, the Cruz folds to:
- With the seat attached: 16.5″ L x 22.8″ W x 33″ H
- Without the seat attached: 12″ L x 22.8″ W x 30″ H
Independent testing from BabyGearLab measured a very similar folded footprint and put the weight around 25 lbs, noting the Cruz “folds fairly flat” and had no trouble fitting in a compact SUV during their testing. Exact numbers can shift slightly between model years (the current generation lists closer to 27–28 lbs), so treat these as a close estimate rather than a guarantee for your specific unit.
Note: Detaching the seat shaves a few inches off the folded length and drops the height slightly, which is the easiest way to reduce a Cruz’s footprint without any tools.
Can the UPPAbaby Cruz Become a Double Stroller?
If the real goal is transporting two kids rather than owning two Cruz strollers specifically, it’s worth knowing what UPPAbaby actually supports. Unlike the UPPAbaby Vista, the Cruz cannot accept a RumbleSeat — that second-seat accessory is built for the Vista’s frame only. The Cruz’s official option for a second child is the PiggyBack board, a standing platform that attaches to the back for an older toddler, rather than a full seated second position.
That distinction matters for trunk space: a Vista-plus-RumbleSeat setup folds as one connected unit, while two separate Cruz strollers are two independent folded frames that each need their own footprint in the trunk. If you’re choosing between buying a second Cruz or switching stroller systems, that’s the core trade-off.
Pro Tip: If your trunk genuinely can’t handle two full-size strollers, a Cruz plus a PiggyBack board (for a child old enough and heavy enough to stand and hold on) takes up only marginally more room than a single stroller.
Tips for Fitting Two Strollers in Your Trunk
A few practical adjustments make it much easier to get two folded Cruz strollers into a tight trunk:
- Detach the seats first — it shaves a few inches off the folded length on each stroller.
- Fold both strollers completely and lock the fold before loading; a partially folded frame takes up more room and can spring open.
- Load one stroller upright against the seatback and lean the second one at an angle or on its side alongside it, rather than trying to stack them flat.
- Store canopies, cup holders, and other detachable accessories separately in a bag instead of leaving them clipped on.
- Measure before you buy a second stroller if you’re shopping specifically to pair it with a Cruz you already have.
Warning: Don’t try to force off wheels or parts that aren’t designed as user-removable to save space — on most full-size strollers, including the Cruz, that can damage the frame or void the warranty. Check your stroller’s official user guide before disassembling anything beyond the normal fold.
Best Packing Techniques for Two Folded Strollers
Beyond the basic fold-and-angle approach, a few habits make repeated loading and unloading smoother:
Fold and load the heavier or bulkier stroller first so it sits against the seatback, then fit the second stroller into the remaining space — it’s easier to adjust the angle of the second unit than to rearrange both.
Keep other cargo — grocery bags, diaper bags, a car seat base — loaded around the strollers rather than on top of them, and avoid piling anything high enough to block your rear window visibility.
Make sure both strollers are clean and dry before loading them, since a wet fold can leave moisture trapped against your trunk carpet or other gear.
Pro Tip: If you load and unload two strollers regularly, folding them in the same order every time (and always leaning the second one the same direction) turns a fiddly process into a quick habit.
Key Features to Look for in a Trunk-Friendly Stroller
When comparing strollers for trunk compatibility — whether you’re adding a second Cruz or considering a different model — a few features consistently make loading easier:
- Compact folding mechanism: A stroller that folds flat (rather than into a bulky bundle) is easier to angle into odd trunk shapes.
- Low folded weight: Lighter frames are easier to lift and maneuver one-handed while holding a child or bags.
- Detachable seat or canopy: Removable components shrink the folded footprint without tools.
- Self-standing fold: A stroller that stands on its own when folded is easier to position upright against a trunk wall.
What Trunk Size Typically Determines Fit
Fit ultimately comes down to your specific vehicle’s cargo dimensions rather than the stroller alone. As a general guide, sedan trunks typically run in the roughly 13–20 cubic foot range and are the most likely to feel tight with two full-size strollers. Compact-to-midsize SUVs generally offer somewhere around 20–40+ cubic feet behind the rear seats, and minivans usually provide the most usable space, particularly with the third row folded or removed. Because published cargo volume doesn’t tell you the trunk’s exact shape, two strollers that fit easily in one SUV model can be a tight squeeze in a different vehicle with a similar headline number — there’s no substitute for measuring your own car.
Alternatives When Two Strollers Won’t Fit in Your Trunk
If your measurements show two Cruz strollers simply won’t work, a few alternatives are worth considering before assuming you need a bigger car.
Consider a Compact Stroller for One Child
Swapping one Cruz for a smaller, umbrella-style or compact-fold stroller can free up meaningful trunk space while still giving each child their own seat. Look for models specifically marketed as compact or travel strollers, and check their published folded dimensions against your trunk measurements the same way you would for the Cruz.
Explore a True Double Stroller
A side-by-side or tandem double stroller that folds as a single unit can sometimes take up less combined trunk space than two separate full-size strollers, since you’re no longer managing two independent frames. If you’re regularly transporting two children together, it’s worth comparing a dedicated double stroller’s folded footprint against the combined footprint of two Cruz strollers before deciding.
Warning: Whatever combination you choose, avoid stacking strollers or bags high enough to block your rearview mirror or obstruct sensors near the rear window — that’s a visibility and safety issue, not just a packing inconvenience.
Frequently Asked Questions
Can the UPPAbaby Cruz be a double stroller?
Not in the way the Vista can. The Cruz doesn’t accept a RumbleSeat, so it can’t run two seated children on one frame. Its official second-child option is the PiggyBack standing board, which works for an older toddler rather than an infant or a second seated child.
How big is the UPPAbaby Cruz when folded?
Per UPPAbaby’s own specs, it folds to about 16.5″ L x 22.8″ W x 33″ H with the seat attached, or 12″ L x 22.8″ W x 30″ H with the seat removed. Weight is typically in the mid-to-high 20-lb range depending on model year.
Can the UPPAbaby Cruz be gate-checked?
Yes, the Cruz can be gate-checked like most full-size strollers, following your airline’s standard gate-check process. Its compact fold makes it easier to hand off and collect at the jet bridge than bulkier models.
Do I need to remove the wheels to fit two Cruz strollers in a trunk?
Not normally. Folding the stroller fully and detaching the seat is usually enough to create a workable footprint. Avoid forcing off wheels or other parts that aren’t designed to be user-removed, since that risks damaging the frame.
Will two UPPAbaby Cruz strollers fit in a sedan trunk?
It depends on the sedan. With trunks generally running in the 13–20 cubic foot range, it can be tight, but many owners manage it by detaching the seats and angling one stroller diagonally. Measuring your specific trunk against the Cruz’s folded dimensions is the only reliable way to know.
Conclusion
Whether two UPPAbaby Cruz strollers fit in your trunk comes down to comparing two sets of numbers: the Cruz’s folded dimensions (about 33″ H x 23″ W x 16.5″ L with the seat on) and your own vehicle’s cargo space at its narrowest points. Sedans tend to be the tightest fit, while SUVs and minivans generally have room to spare. Detaching the seats, folding both strollers fully, and loading one upright with the other angled beside it solves the problem for most vehicles — and if it still doesn’t work, a compact single stroller, the PiggyBack board, or a true double stroller are all reasonable alternatives worth measuring against your trunk before you buy.
